Water Heater Maintenance Tips

At the end of the day, you want to be able to take a nice hot shower or bath. But if you have a problem with your water heater, then that nice hot shower or bath might have to wait. Fortunately, with our water heater maintenance guide, you can prevent issues that could get in the way of your comfort.

Five Steps for Maintaining Your Hot Water Heater

Keep your appliance in good working order by following these five steps:

  1. Clear space around the appliance. If your water heater is located in a room you typically use for storage, make sure it’s free of clutter. It can easily happen that you don’t notice clutter building up and getting too close to the appliance. However, you should maintain at least two feet of clearance around it in order for it to operate safely and properly.
  2. Shut off the water supply and the power. In order to perform maintenance, you need to be safe. Turn off the power supply—the switch will be located close to the water heater—and shut off the water supply valve.
  3. Test the TPR valve. The TPR valve is the temperature-pressure relief valve. This valve opens to release vapor if the pressure inside the tank gets too high, so it needs to be working properly. Place a bucket below the pipe under the TPR and open the valve quickly two to three times. If the valve leaks, it will need to be replaced.
  4. Check the anode rod. The anode rod is housed inside the water tank. Its function is to attract minerals and other elements that could corrode the tank. Over time, the anode rod can will either corrode or get coated with calcium, at which point you’ll need to replace it. To check it, lift the anode rod out of the tank and visually inspect it. If it’s coated in sediment or if it’s less than half an inch in diameter, you should purchase a new one.
  5. Flush the tank. You need to flush the tank several times a year to prevent sediment from building up inside of it. To do this, attach a hose to the drain valve and let all of the water drain out of the tank into a bucket. This will remove most of the sediment. If the water is cloudy, briefly open the cold water supply valve to let more water into the tank. Stir the sediment, then drain the tank again. Repeat this process until the water coming out of the tank is clear.

Insulate the Tank and Pipes

Did you know that you can save energy and protect your pipes from cooler temperatures by insulating your water heater tank? You can purchase special insulation sleeves at your local hardware store or online. Note that modern models have built-in insulation, so check the manufacturer’s manual before investing in any insulation materials for your hot water heater.

How Anthony’s Can Help

If your water heater needs professional work, give us a call. Our water heater technicians have seen every problem possible, and we’ve got a fully up-to-date arsenal that will let us solve any issue you have, including (but not limited to):

• Faulty temperature sensors
• Improper installation.
• Sediment build-up in pipes
• Defective heating element
• Damaged pilot light
• Corrosion
• Leaks around fittings or valves

At Anthony’s Plumbing, we want you to have the best possible equipment at the fairest price. We offer deals on American-made, Bradford White brand water heaters that are high efficiency, affordable, and durable so you won’t need to worry about another breakdown anymore.

For all of your water heater needs, call Anthony’s Plumbing today!